欢迎访问busbarcuttingmachine官方网站!

+8613853146766

Cut off the nodes of high-voltage lines and the classification of power plants

Source:wenhui  Date:2020-07-23 16:52

Cut off the nodes of high-voltage lines and the classification of power plants

Line maintenance

● Equipment installation

cutting and bending machine

● Reduce line load

     The above are artificial, planned removal of the route

● Cut off the line in case of failure

bending machine manufacturers

     Irregular, anytime, anywhere, because the fault is uncertain-so an automatic removal device is needed, which is the relay protection device.

1. Thermal power plant: A factory that converts the chemical energy of coal, oil, natural gas or other fuels into electrical energy.

sheet metal forming machines

It is mainly composed of three parts: combustion, soda, and electrical system; it can be divided into two types: gas-fired thermal power plant and thermal power plant

Normal operating life is 25 years.

2. Nuclear power plant: all use the energy released during nuclear fission to generate electricity.

3. Hydropower plants: use hydropower to generate electricity, which can be divided into three types: dam type, runoff type (such as Gezhouba), and pumping animal energy; the hydraulic unit is flexible and can quickly adapt to the sudden change in load, generally from unit startup, grid connection to belt The load can be completed in just a few minutes; the operating life is usually 50 years.

4. Wind power plant

All product pictures existing in this catalog are representative and may not have exactly the same appearance and features with the machines to be produced later. Machine appearances and features are subject to change without any prenotification.